PaintNuts 'All you need' Colour Matched Spray Paint Bundle

PaintNuts Panel Wipe Shake aerosol for at least 2 minutes to ensure the panel wipe is mixed correctly Either vertically or horizontally apply in smooth cross coats 250mm distance from the repair area. Immediately wipe the area with the PaintNuts degreasing cloth ensuring you don't allow the panel wipe to dry out - if it does, reapply then wipe dry. Wipe with the provided sticky tack rag to remove any remaining dust particles Repeat this process at each stage prior to application of primer, paint and lacquer to ensure a clean surface for application   PaintNuts Grey Primer Aerosol Shake the aerosol thoroughly for at least two minutes, after the agitator ball is free to ensure the primer is mixed correctly. Apply in cross coats from a distance of 25cm from the object, ensuring you only apply the primer witin the intended area. Leave the primer to dry for 10-25 minutes before applying a second coat if required. Leave the primer to cure 24 hours before applying the colour matched paint.   Norton Topcoat Sanding Paper Step 1: Ensure primer is fully dry before sanding Step 2: Using the 600 grit sheet sand the primed surface area, removing any defects and dirt particles – sand in one direction only to achieve an even scratch pattern. Step 3: With the 800 grit paper, sand the full repair area to remove scratches from step 2. Again sand in one direction for an even finish. Step 4: With the 1000 grade paper, sand the full repair area ensuring all scratches from step 3 are removed. Continue to sand in one direction. Fully degrease and wipe the repair area, ensuring the surface is free from dirt Tip: For best results use the grits in sequence, apply even pressure when sanding and use a sanding block for an even finish, for use by hand and use dry.   PaintNuts Colour Matched Paint Aerosol Prepare & Clean: The surface must be clean and dry - make sure all wax, polish and grease is removed. Use the PaintNuts Panel Wipe spray and Degreasing Cloth to clean, and then the sticky tack rag provided to remove any remaining dust particles. Shake & Test: Shake can for 2-3 minutes to ensure the paint within the can is mixed. Before applying the car spray paint to the vehicle, we recommend testing the colour and which spray pattern you require; you can adjust the nozzle to spray horizontally or vertically. On white card - check how many coats you require to match the original colour. Too few coats will look too light, too much car spray paint / too many coats will make the colour too dark. Paint & Finish: Either vertically or horizontally apply in smooth cross coats 250mm distance from the repair. Leave to dry for 15 minutes before applying a second coat of car spray paint if necessary and leave 4 hours before applying PaintNuts lacquer. After use, turn the car paint spray upside down to empty nozzle valve to clean then it can be reused at a later date. Please note: Aerosols should not be applied in cold, damp weather – it will adversely affect the application, finish, and drying time. The recommended minimum temperature for using car spray paint is 15 degrees, preferably room temperature indoors in a warm and well-ventilated area.   PaintNuts Clear Lacquer Aerosol Ensure the surface is clean, dry and free of any dust or grease Minimum application temperature is 15 degrees Celsius Apply in cross coats at a distance of 250mm, leaving 3-5 minutes between coats Drying time: 10 - 25 minutes; Fully Cured: 24 hours After use, turn the can upside down and spray until the valve is clean preventing the valve from clogging up