Small Scale Banner Set (H) – Back Banner Type suits Adeptus Titanicus / Epic etc

DescriptionThis set is printed to a high standard in ceramic gray photopolymer resin.Supplied unpainted and unassembled.This 27 part can be built into a single back banner in a large number of ways.It is designed for easy transport to be attached to its mount by means of the included magnets. The mount is ball jointed to allow setting in a variety of positions and on a wide range of models.This kit is compatible with the previous PLA version with minimal work (if you use the same magnet polarity). Revised design – this kit is now printed in resin with pre-curved banners and finer detail than previous versions.Painted example using previous PLA / FDM print. The new resin version is far superior.This set can be used either with printed paper banners or using the pre-curved resin banners.Cleanup will be required and is most easily done with a sharp, new #11 x-acto blade.Miniatures pictured are not included, and are for illustrative purposes only.Designs are under constant revision and improvement. As such, the product may vary slightly from pictured.